Of 15 n m 11 ft lb.
Powerfab solar panel frame instructions.
Solar panel frame parts should be stuck firmly to the laminate.
Fasten the screw applying torque.
Wire the battery to the charge controller and then the solar panel to the charge controller ensuring the correct polarity is observed see.
I did spay a clear coat on the cell to.
Fastening the power optimizer to the pv module.
Tpm the power fab tpm is designed to install quickly and provide a secure mounting structure for pv modules on a single pole.
Before after installation 5 3.
A bare copper stranded 6awg wire attaches to each solar panel frame these go into the combiner box to a ground bus bar.
Put all the cells on the card board put the plastic on top and bottom assembled the frame and ran a small bead of silicon around the frame to water proof and seal it.
Place the piece on the solar panel so that the dowel is in the exact center of the array and temporarily tape it in place.
A solar panel mount or solar racking system is the foundation that holds your solar array in place.
Do not touch the glass surface or frame of the solar module after installation of the module.
Pass the cable from the solar panels to the interior see section 6.
Determine the mounting location of the solar panel s.
The positive leads from each string go to breakers in a combiner box.
Everything seams to be working so far.
The metal frame work that holds and supports my solar panel array is grounded.
Power fab multi pole pv mounting mpm g2 system the power fab mpm g2 ground mount is designed to install quickly and provide a secure mounting structure for pv modules on a single row of vertical pipe.
Adjust the panel until the dowel has no shadow whatsoever around it and your solar panel is now facing head on into the sun.
Insert the bracket back plate underneath the module frame.
The module specific design reduces the number of components and provides for an easier assembly.
With proper installation a sturdy mount secures your panels in harsh weather and protects your investment.
Pv solar module installation manual en.
1 manufacturer part number.
Mount the charge controller at the desired location see section 5.
Mounting the power optimizer on the module frame.
Mounts are used to attach solar panels to the roof ground or another surface on your property.
Electrical installation 7.
The negative leads go to a negative bus bar in the combiner box.
This should be achieved mechanically on the inside edges of the backside of the solar panel frame.
To install a frame mounted power optimizer on a pv module.
In the center of a piece of plywood or plastic mount a 1inch x 12 inch dowel.
