Failure to install and maintain our product according to these instructions may void any product warranty.
Ptac wall sleeve installation instructions.
16 24 28 and 31 deep cases are available for thicker walls.
For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames.
Consult a licensed contractor as needed.
In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended.
See the drain kit for internal actual installation instructions.
For sunrooms and modular buildings adhere to their installation instructions for supporting and sealing sleeve to their frames.
To ensure proper airflow and filter removal it is recom mended installation of the wall sleeve be a minimum of 36 from the ceiling.
The wall sleeve be installed a minimum of 36 from the ceiling.
The air conditioner will slide into the sleeve but is not flush with the wall.
If the sleeve projects more than 8 into the room a sub base or other means of support must be used.
Wall sleeve installation 920 087 04 8 05 wall sleeve installation instructions pdxws note.
Prepare and install the new wall sleeve according to the instructions below.
Wall case must be sealed caulked to outside wall on all four 4 sides.
In applications where the drain holes on the ptac wall sleeve are not exposed beyond the wall an internal drain system is recommended.
Inches mm inches mm inches mm wall sleeve only 3 75 0 0 0 0 subbase kit 3 75 3 1 4 85 2 3 4 70.
Standard steel wall cases are 42 w 16 h 13 3 4 d.
Insure that the unit is only installed in a wall structurally adequate to support the unit including the sleeve chassis and accessories.
For new installs ensure the wall is properly framed to support the weight and dimensions of the wall sleeve and air conditioner.
When a drain kit is to be installed do so before top of wall sleeve installing the wall sleeve in the wall.
All wall and window wall installations must provide for proper drainage.
Wall case should be sealed caulked to the inside wall on all four 4 sides.
All wall and window wall installations must provide for proper drainage.
Page 3 pre installation considerations before proceeding with the sleeve installation ensure the following guidelines for locating the wall opening and sleeve are met.
This information might be about you your preferences or your device and is mostly used to make the site work as you expect it to.
There is a portion of the air conditioner which extends a few inches back into the room.
Tools required by.
Figure 4 minimum interior and exterior note.
Installation guidelines for sealing ptac sleeves read these instructions completely before starting any installation.
The wall sleeve must be fastened securely before installing the air conditioner unit.
